TFM 13 Texas Fire Alarm Technician 13 – Technical Practice Test

These questions are part of the practice quiz. Start practicing

• What is NOT a requirement for the secondary power source for household alarms?
• Who is primarily responsible for ensuring that fire alarm systems meet relevant codes?
• What may be required if modifications are made to a fire alarm system?
• Where must heat detectors be mounted on the ceiling in relation to the wall?
• What must be done if a component within a smoke detector fails?
• Which type of mechanism can power smoke alarms?
• In which circumstance should fire devices not be installed?
• What is the scanning process in a fire alarm system?
• What is a consequence of not maintaining fire alarm systems regularly?
• Fixed temperature detectors shall not be rated more than how many degrees higher than the maximum ambient temperature?
• What is the intended function of smoke alarms located near stairs leading to occupied levels?
• A DACT serving the protected premises shall only require how many telephone lines?
• What is the primary difference between ionization and photoelectric smoke detectors?
• What is amperage in the context of fire alarm systems?
• What does "decibel" refer to in fire alarm systems?
• Can smoke or heat alarms be interconnected in numbers that exceed the manufacturer's instructions?
• What distance limitation exists for the installation of smoke alarms near ceiling fans?
• Why is routine maintenance essential for fire alarm systems?
• Smoke alarms or smoke detectors mounted on a peaked ceiling must be located within how many inches horizontally of the peak?
• What is the main purpose of a fire alarm control panel?
• Which type of signals must take priority over all others in a fire alarm system?
• How should interconnected fire alarm devices be structured to prevent faults?
• What should personnel do if a fault in the fire alarm system is indicated?
• What is an out-of-service fire alarm system?
• Which of the following is NOT a type of smoke detector?
• What is the maximum voltage for electrical systems not designed to be installed by an electrician?
• What is the required spacing between smoke detectors in a hallway?
• What does "alarm signaling" entail?
• What advantage does a remote monitoring service offer to fire alarm systems?
• What is the nature of the enclosure that contains the means to silence trouble/supervisory/alarm signals?
• How should smoke detectors and notification appliances in household fire alarm systems be managed?
• Why must fire signals be distinct from other signals in a fire alarm system?
• AC primary power must be supplied by which of the following?
• What purpose do fire alarm test and inspection records serve?
• Which of the following is NOT an optional function of fire warning equipment?
• What is the primary function of a notification appliance in a fire alarm system?
• What is the function of a receiver in a fire alarm system?
• At what height should fire alarm pull stations be mounted?
• For sloped ceilings, how far should a detector be located from the peak?
• What type of fire alarm system is typically used in large buildings?
• Before allowing the silencing of signals, what type of warning must accompany the visual warning?
• What action should be taken if a fire alarm system is found to be malfunctioning during routine checks?
• What is the maximum distance a smoke detector should be from a cooking appliance?
• Can smoke or heat alarms from different manufacturers be interconnected?
• A rechargeable battery must be capable of producing a trouble signal at least _______ a minute for _________ consecutive days?
• What is a benefit of using AFCI technology in electrical systems?
• Which component is primarily responsible for receiving signals from fire detectors?
• What is the function of a notification appliance in a fire alarm system?
• What is typically the maximum distance between smoke detectors in a commercial setting?
• What does the term "common area" refer to?
• Why is a fire alarm system's voltage relevant?
• What is the required distance between a smoke detector and a ceiling fan blade?
• What does GFCI stand for?
• Is the statement "Chapter 11 applies to the protection of property" true or false?
• What must happen to the system control equipment when power is restored after being lost?
• Which area must have a smoke alarm installed according to the specified requirements?
• For smoke alarms powered by a primary battery, what must the weekly testing ensure?
• What is the primary purpose of a fire alarm control panel?
• How does a photoelectric smoke detector operate primarily?
• What should fire equipment not compromise if installed for other functions?
• Which component is most responsible for alerting occupants in case of fire?
• How long must a secondary power source for household alarms function during an alarm?
• How often should household fire alarm systems be inspected?
• What factor determines whether an area needs a manual or automatic alarm?
• What is the maximum allowable delay for remote monitoring facilities to contact a monitored property?
• What is the impact of poor battery maintenance in fire alarm systems?
• Smoke alarms and detectors must not be located in unfinished attics or garages if temperatures can fall below what temperature?
• All wiring and equipment installations must comply with which code?
• Which of the following is a requirement for smoke alarms in multiple dwelling units?
• Which condition is NOT part of the installation rules for fire devices?
• If a rechargeable battery is used, it must be fully recharged within how many hours?
• What determines the distance a fire alarm circuit can cover without a repeater?
• Smoke alarms installed in areas with varying temperatures above 100°F must meet what type of requirement?
• Which type of facilities would greatly benefit from an addressable fire alarm system?
• What can be a consequence of failure to comply with fire alarm system codes?
• Can a smoke alarm be connected to a switched outlet?
• What is the maximum length of a fire alarm circuit between devices without needing a repeater?
• What factor alters the installation requirements of smoke detectors in slanted areas?
• What is indicated by a distinctive trouble signal in alarm systems?
• What must smoke alarms powered by AFCI have?
• Any failure of non-reliable or short-life components within a detector shall result in what?
• In a staircase scenario, what is crucial for the effective functioning of smoke alarms?
• Under which scenario must a fire alarm system initiate a pre-signal?
• Operation of a switch or GFCI shall not cause loss of what?
• What type of smoke detector is best for areas with high airflow?
• What is the first requirement before installing a means to silence trouble/supervisory/alarm signals?
• What is the purpose of an alarm verification feature?
• What feature helps reduce the likelihood of a fire alarm being triggered falsely?
• When might an existing fire alarm system require re-certification?
• How often should smoke detectors be replaced according to fire safety guidelines?
• A trouble signal from a detector indicates what?
• What does a "fault" indicate within a fire alarm system?
• What is the maximum travel distance for smoke alarms from any point on the ceiling?
• What form of communication is utilized for alarm signaling?
• Who is responsible for informing a technician about occupants with hearing disabilities?
• What are the main components of a fire alarm notification circuit?
• What should the secondary source for household alarms provide when in low battery condition?
• How often should fire alarm systems be inspected and tested?
• What is the minimum testing frequency for the operability of smoke alarms?
• What is the main purpose of a heat detector in a fire alarm system?
• For sloped ceilings with a rise greater than 1m in 8m horizontally, where should the smoke detector or alarm be located?
• What is the standard for emergency evacuation signals?
• What is the minimum operational duration required from a secondary battery power source for fire alarms?
• What is the purpose of a fire watch?
• When installing detectors on an open joisted ceiling, what should be the maximum spacing for heat detectors or alarms measured at right angles to solid joists?
• What feature is crucial for the operation of fixed temperature heat detectors?
• What device is used to alert occupants in case of fire?
• What is the significance of system redundancy in fire alarm systems?
• What is the minimum allowable horizontal distance for smoke detectors placed near HVAC vents?
• Smoke alarms and smoke detectors within a horizontal path of a cooking appliance must have what?
• What is typically the required height for mounting smoke detectors?
• What conditions must be met for non-fire alarm equipment to be integrated with a fire alarm system?
• In fire alarm systems, what does the term "active device" refer to?
• Why is it important that smoke alarms be placed correctly on sloped ceilings?
• Detectors and appliances shall be protected from damage by a mechanical guard as long as what condition is met?
• How far must smoke alarms be installed from a door to a bathroom containing a shower or tub?
• Which type of circuits typically utilize Zone 4 in fire alarm communications?
• All detectors must be provided with a convenient means of what?
• What is one way to ensure proper spacing of heat detectors or alarms?
• What is the primary function of a fire alarm system?
• In which situation would a fire watch typically be required?
• According to the National alarm code, low power wireless systems must comply with which section?
• What does a Class A circuit signify in fire alarm systems?
• Can the emergency evacuation signal also serve other devices?
• In fire alarm systems, what is typically the first step in response to a detected fire condition?
• What is the key benefit of using a programmable fire alarm control panel?
• What must all plug-in installations have?
• What must be verified before proceeding with fire alarm system installation?
• Which of the following is NOT a basic requirement for fire warning devices?
• What is the purpose of the National Fire Alarm and Signaling Code (NFPA 72)?
• How far from AC power lines should fire alarm cables be installed?
• What determines the installation location for fire protection equipment?
• Fixed temperature detectors shall have a rating of at least how many degrees above ambient temperature?
• Which type of fire alarm system connects to the building's existing fire alarm system without needing its own power supply?
• What is one way smoke and heat alarms may be powered?
• What is the primary purpose of fire warning equipment?
• In what range should smoke alarms be installed vertically to the peak of a peaked ceiling?
• What kind of signal indicates a fault in interconnected devices?
• What color wires are typically used for fire alarm circuit disconnection?
• What is one requirement of power sources for smoke alarms?
• If smoke alarms are powered by a primary battery, all power requirements must be met for at least how long?
• In supervised systems, what is the maximum number of initiating devices allowed?
• What is the requirement for rechargeable batteries used in smoke alarms?
• What is the key requirement for smoke alarms installed near open stairways?
• In what situation may a GFCI reset itself automatically?
• What does a grounding system in electrical installations help to prevent?
• What is the minimum operational period for a commercial power source for alarm devices?
• In case of failing smoke alarms, what action must be noted in the provided information?
• True or False: Detectors and appliances can be mounted using wires behind them.
• A list of acceptable replacement batteries must be placed by the manufacturer in what location?
• How can regular maintenance of fire alarm systems impact their effectiveness?
• What kind of smoke detectors should be used if located near cooking appliances?
• What is the minimum horizontal distance smoke alarms should be installed from the tip of a ceiling suspended fan?
• How often should Digital Alarm Communicator Transmitters (DACT) test signals be transmitted?
• Neither loss nor restoration of primary power shall cause what?
• When is voice notification incorporated into fire warning equipment?
• If secondary power is provided, what must the primary power source be capable of?
• If the mounting location of smokes and heats gets higher, the listed spacing must be adjusted. True or False?
• How can the effectiveness of a fire alarm system be improved during design?
• What is the primary purpose of smoke detectors in a fire alarm system?
• Is a visible notification appliance required to be supplied with a secondary power supply?
• Which function can be included with fire warning systems according to safety regulations?
• What aspect of fire alarm systems can a remote monitoring service improve?
• What should be done if smoke or heat alarms exceed the spacing manufacturer's instructions?
• Smoke alarms or detectors should be located where smoke rising in the stairway cannot be obstructed by what?
• What type of fire alarm device is designed to detect flames?
• What indicator must be visible on all AC power primary sources?
• What is the minimum height for installing smoke alarms from the ceiling?
• When a fire alarm system activates, what is the first action that should be taken?
• Where should fire alarm system batteries be located?
• In relation to smoke alarms and obstructions, what should be avoided to ensure proper function?
• What is the maximum number of initiating devices permitted in unsupervised means?
• Are Low Power Wireless Systems allowed for signal transmission in protected dwellings?
• What rule pertains to smoke rising up a stairway?
• How should spacing for smoke alarms be assessed in relation to solid joists?
• For open joisted ceilings, what regulation affects the spacing of heat detectors?
• What does "DACT" stand for in fire alarm systems?
• How should heat detectors be positioned on walls?
• For sloped ceilings with a rise greater than 1 in 8, smoke alarms must be located how far from the high side of the ceiling?
• Which feature is essential in a fire alarm control panel?
• Which component must signal an audible trouble when the system is in 'silent' mode without any existing trouble?
• Which printed information must be included by the installer regarding smoke alarms?
• In which location is a manual pull station required?
• What safety standard governs the performance of fire alarm panels?
• Why are common areas important in fire alarm planning?
• What shall installers provide to the occupant regarding the fire alarm system?
• What does AFCI stand for?
• Which of the following measurements indicates the maximum spacing for smoke detectors on sloped ceilings with steep angles?
• Which agency regulates fire alarm installations in Texas?
• What happens during a fire alarm "reset" procedure?
• How are fire alarm systems monitored?
• A single fault on the interconnecting means between multiple station alarms shall not prevent what?
• What does the term "response time" refer to in the context of fire alarms?
• What does the term "zone" refer to in fire alarm systems?
• Which of the following is a requirement for installing safety alarm systems?
• Where must detectors be installed according to requirements?
• What is the required clearance for smoke sensors from the sidewall?
• What is a major factor in the selection of fire alarm systems?
• What determines the required number of smoke detectors for a commercial building?
• What is the maximum allowable time for the evacuation pause during a fire alarm?
• What assumption does Chapter 11 make about occupants of a building?
• What is the minimum decibel level for fire alarm systems in sleeping areas?
• Each heat detector shall be listed for spacing of not less than which distance?
• When installing smoke detectors, why is it important to consider ceiling height?
• What is the key function of a strobe light in a fire alarm system?